Dycon Battery Powered Floor Scrubber In 18 Inch And 20 Inch Brush
With Grey Color
Features.
1, The machine is walk-behind floor scrubber of battery type
2. system with automatic assembly and disassembly design without
any tools for operation
3. With clean water filter system and electromagnetic valve device,
saves a lot of water for your
4. Transparent cover for the recovery tank, easy to check the
situation inside the tank;.
5. unique brush compression system is very fit for stubborn dirt
6. Side-open recovery tank, easy to put or pull out the battery
7. applicable to factories, workshops, property cleaning, shopping
malls, supermarkets, airports, subways and so on
8. Non skid antiskid large wheel rubber main wheel. Antiskid and
wearable, long service life
9. Zero swing, easy to operate
10. humanized design, driving comfort, nimble, high cleaning
efficiency
| Model | FS45 |
| Brush Dia.(mm) | 510mm(A)/458mm(B) |
| Squeegee Width(mm) | 850 |
| Solution Tank(L) | 40 |
| Recovery Tank(L) | 45 |
| Brush Driving Mode | metal gear reduce |
| Brush Speed(rpm) | 200 |
| Brush Motor(W) | 500 |
| Suction Motor(W) | 550 |
| Traction Motor | 500 |
| Efficiency(m2/h) | 2000 |
| Installed power | 24V |
| Battery | 12Vx2 120Ah |
| one key control | Yes |
| Dirty water level sensor | Yes |
| Driving speed adjust | Yes |
| |
| loading | 26pcs/20ft |
| 54pcs/40GP |
Introduce
Modern floor scrubbers have a pre-sweep option that removes the
need to sweep the floor before scrubbing. The pre-sweep brush head
is placed in front of the vacuum system to collect dust and debris
before it can block the vacuum system. In the past it was important
to sweep the floor before scrubbing to remove any debris and dust
that could clog the vacuum hose or build up in the vacuum motor,
which can decrease performance. If this happens, the vac hose may
need to be removed to clear the obstruction and/or the vac motor
may need to be blown out with compressed air. Stripping Solution
should never be used as it can cause damage to the solution
dispensing system, but can still be vacuumed up by the machine
without harm.
Occasionally, the solution system should be flushed with water
mixed with vinegar to remove any soap and calcium deposits that
could build in the solution system.
After each use, the dispensing (solution) and especially the
collection (recovery) tanks should be emptied and rinsed out to
prevent dirt build up. Also, the
pads/brushes, vac hose, and squeegee should also be rinsed to
prevent dirt build up. The vac motor should be run for several
minutes afterwards to remove any moisture
that could be present in the vac motor to reduce chances of
corrosion that could damage the vac motor. Failure do to this
maintenance could cause in a loss of vacuum
airflow and increase in costly repairs.
Order Tracking
1.Once you place order to us, we will track your order immediately,
let you know the newest process until you have received it.
2.We will be more than happy to give you reply within 12 hours if
you have any questions and requests.
